i just hooked up the sli cable. in the nvidia settings its set to "all" in the cuda section i see nothing that says to turn on sli. restarted and still only crunching 1 workunit. this is on dirt. what am i doing wrong?
i just hooked up the sli cable. in the nvidia settings its set to "all" in the cuda section i see nothing that says to turn on sli. restarted and still only crunching 1 workunit. this is on dirt. what am i doing wrong?
Last edited by GregK; 11-20-12 at 06:44 PM.
yes but it says (not used).
doesnt show (2) in the project in my computer section either but im sure thats because they havnt updated yet?
You can try forcing BOINC to use both GPUs by adding <use_all_gpus>1</use_all_gpus> to your cc_config.xml file.
cc_config info ---> http://boinc.berkeley.edu/wiki/Client_configuration
ill try more tomorrow. also just rcvd. 650w psu so i can get the 6870 going. all tomorrow to tired tonight.
Could be the Video Card Drivers haven't installed properly ... Try re-installing them again
Very good point!
Hmmmm.... OK download the attachment and rename it by changing .zip to .xml then copy it to your BOINC Data folder. If you have a cc_config file there already then select to overwrite it when prompted by Windows.
cc_config.zip
i did it but still only 1 wu crunching. idk i will figure it out eventually.
Last edited by GregK; 11-22-12 at 10:43 AM.