Page 3 of 11 FirstFirst 12345 ... LastLast
Results 21 to 30 of 104

Thread: Need Recommendations on a New Build

  1. #21
    Past Admin
    Mike029's Avatar
    Join Date
    October 24th, 2010
    Location
    Bronx, New York
    Posts
    3,377

    Re: Need Recommendations on a New Build

    Quote Originally Posted by Bryan View Post
    My bad, I was thinking of the 5690!! My machines are the 5675s.
    No, my bad, I should have only put up a six core as recommended. How about this one? http://www.ebay.com/itm/Dell-Precisi...YAAOSw3ydVmwCW
    It's a bit more. Unless you think I can wait for a better price as there is not much of a selection on the x5675. Must be a popular cpu.



  2. #22
    Administrator
    Bryan's Avatar
    Join Date
    October 27th, 2010
    Location
    CO summer, TX winter
    Posts
    6,457

    Re: Need Recommendations on a New Build

    Not bad, but I'd be more inclined to go for the 5680 @ 3.33G and 48G HERE. The 5680 is 10% higher clock rate and for less than 20 bucks it would be a shame not to bite.

    I know Z will disagree, but 1 of my machines has 48G and 2 only have 24G. There have only been a couple of times that I couldn't run 24 threads on a project. On those I had to drop all the way down to 20 threads So if the machine is a little pricey you might consider looking for one that has the higher speed processor and getting less memory. At a later date you could upgrade the memory .... for $188 bucks you can get 48G.

    The memory configuration is kind of oddball. IIRC you get a choice of 24G or 48G but nothing in between. You can download the users manual and it shows the valid configurations. I don't think you can start w/ 24G and then add another 24G to bring it to 48.

    With regards to price, I bought my 1st over a year ago and it was at about the same price. I don't think they fluctuate.


  3. #23
    Ambassador from TSBT scole of TSBT's Avatar
    Join Date
    May 8th, 2015
    Location
    Goldsboro, NC
    Posts
    1,031

    Re: Need Recommendations on a New Build

    Anyone running dual X5680 or X5690s in a T5500/T7500 or Z600/Z800? What are your temps like and what mods did you do? I figure at 130 watts, those are little tougher to keep cool compared to the 95 watt x5675/x5670/x5650 cpus. On my dual x5675 system, I ditched the aluminum heatsink on the main board CPU and put this one in http://www.ebay.com/itm/171183521047 and strapped a 92mm case fan to it. Plus I mounted 2 92mm fans in the back to pull air out and pulled the front cover off and have a small floor fan forcing air through it. May sound like a lot, but room stays warm with 3 systems in there.

  4. #24
    Administrator
    Al's Avatar
    Join Date
    May 18th, 2011
    Location
    Chapel Hill, NC
    Posts
    6,820

    Re: Need Recommendations on a New Build

    Quote Originally Posted by scole of TSBT View Post
    On my dual x5675 system, I ditched the aluminum heatsink on the main board CPU and put this one in http://www.ebay.com/itm/171183521047 and strapped a 92mm case fan to it.
    I've been meaning to do that since I got mine. I just picked up 3 @ $10 a pop with free shipping.



  5. #25
    Gold Member
    FourOh's Avatar
    Join Date
    January 16th, 2013
    Location
    Memphis, TN
    Posts
    1,038

    Re: Need Recommendations on a New Build

    I can't see spending the extra $$$ on the 130 Watt X56xx cpus. They cost more on the front end, then use more electricity and create more heat. My x5670 outproduces my x5650 by about 5-10% on most CPU projects, using only a few more watts of power. I'd look for dual x5670 or x5675 in the "bang for buck" category.

    Just remember, these are not enthusiast motherboards, so even if you have the case open with cold air blowing on the internals, the CPUs will typically not run all threads at their rated speed. But they are very stable and can run a high end GPU on the stock PSU.

    I took some power usage measurements on my machines about a year ago... now where did I put those notes



  6. #26
    Silver Member
    MindCrime's Avatar
    Join Date
    February 26th, 2014
    Location
    Portland, OR
    Posts
    969

    Re: Need Recommendations on a New Build

    Quote Originally Posted by scole of TSBT View Post
    Anyone running dual X5680 or X5690s in a T5500/T7500 or Z600/Z800? What are your temps like and what mods did you do? I figure at 130 watts, those are little tougher to keep cool compared to the 95 watt x5675/x5670/x5650 cpus. On my dual x5675 system, I ditched the aluminum heatsink on the main board CPU and put this one in http://www.ebay.com/itm/171183521047 and strapped a 92mm case fan to it. Plus I mounted 2 92mm fans in the back to pull air out and pulled the front cover off and have a small floor fan forcing air through it. May sound like a lot, but room stays warm with 3 systems in there.
    Check this out, http://www.setiusa.us/showthread.php...l=1#post100568

    t5500 with 2x 5650s, 36gb ram, and a 750 ti. I did pretty much what you did. Pulled the passive, added a 92mm fan and my temps are amazing now. Wish i did it immediately after purchasing, I will next time.

  7. #27
    Ambassador from TSBT scole of TSBT's Avatar
    Join Date
    May 8th, 2015
    Location
    Goldsboro, NC
    Posts
    1,031

    Re: Need Recommendations on a New Build

    T5500 w/500GB drive $160 http://www.ebay.com/itm/171985608656
    2nd CPU/memory riser $80 http://www.ebay.com/itm/331702355304
    X5670 x2 $200 http://www.ebay.com/itm/311479761117
    24Gb RAM $60 http://www.ebay.com/itm/161176438347
    Upgraded heatsink and fan $20

    $520

    Those are all buy it now prices, but if you're patient, you can snag some bargains and build it cheaper.

  8. #28
    Gold Member

    Join Date
    August 16th, 2012
    Location
    Milton Keynes, UK
    Posts
    1,314

    Re: Need Recommendations on a New Build

    Quote Originally Posted by Fire$torm View Post
    Question: What are the KW/H costs on dual Xeon vs. dual Haswell-E? And what are the credits per day/KWH ratio's?
    This is called the specific energy, and this ratio should be compared between machines. Basically for the same period of time an energy reading should be taken divided by the number of tasks completed on the same frame period. The ratio should be kWh/tasks.

  9. #29
    Silver Member
    MindCrime's Avatar
    Join Date
    February 26th, 2014
    Location
    Portland, OR
    Posts
    969

    Re: Need Recommendations on a New Build

    On the topic of power and heat. I think we all know that a haswell will get you far more credit per watt. But remember a watt is a watt in heat. Have a 100w haswell or westmere you're adding 100w of heat to the room.

    If that room needs to be heated you've just reduced its need by 100w. I have no idea how cpuboss.com calculates the annual energy costs but a x5675 shows 83$/yr and the 5960x is 122$/yr. Obviously we would double the Xeon cause we're talking about two.

    It'd cost you less than 2 dollars a month more to run the dual Xeon vs a 5690x. If we round up a lot and estimate the dual xeons cost about 24$ more annually it would take a few decades for the energy costs to add up to the capital costs.

    Sent from my A0001 using Tapatalk

  10. #30
    Gold Member
    FourOh's Avatar
    Join Date
    January 16th, 2013
    Location
    Memphis, TN
    Posts
    1,038

    Re: Need Recommendations on a New Build

    I definitely recommend adding two 80mm exhaust fans at the rear, as well as this module which provides a bit of intake air up at the 5.25" external bays:
    http://www.ebay.com/itm/NEW-Dell-WH2...item280a8c1619

    Edit: Thanks MindCrime, it's 80mm fans that fit at the lower rear of the case.
    Last edited by FourOh; 11-09-15 at 05:24 PM.



Page 3 of 11 FirstFirst 12345 ... LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •