Results 1 to 10 of 17

Thread: Free-DC Campaign #12 part 2 is now open on Bitcoin Utopia

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Administrator
    Bryan's Avatar
    Join Date
    October 27th, 2010
    Location
    CO summer, TX winter
    Posts
    6,457

    Re: Free-DC Campaign #12 part 2 is now open on Bitcoin Utopia

    Now that is excellent news!


  2. #2
    Administrator
    Al's Avatar
    Join Date
    May 18th, 2011
    Location
    Chapel Hill, NC
    Posts
    6,767

    Re: Free-DC Campaign #12 part 2 is now open on Bitcoin Utopia

    Quote Originally Posted by Bryan View Post
    Now that is excellent news!
    Are they going to offer a bfgminer wu? Last time I checked they didn't have one yet.



  3. #3
    Platinum Member
    cineon_lut's Avatar
    Join Date
    September 8th, 2013
    Location
    California, U.S.A.
    Posts
    2,505

    Re: Free-DC Campaign #12 part 2 is now open on Bitcoin Utopia

    Turns out my monarch may not be bad. I was getting by with a 550W supply on one Monarch before. I'm thinking the power draw on Campaign 7 is higher than previous projects I ran. The 500W runs it now after I reseated all of the fan controllers on the Monarch, but trips off as soon as it's under load.

    SO: Crazy question, I have 3x6pin inputs on the Monarch. Is it possible to split the load on those between 2 500W power supplies? I'm thinking no, but I just wanted to check if anyone has done it.

  4. #4
    Administrator
    Al's Avatar
    Join Date
    May 18th, 2011
    Location
    Chapel Hill, NC
    Posts
    6,767

    Re: Free-DC Campaign #12 part 2 is now open on Bitcoin Utopia

    Quote Originally Posted by cineon_lut View Post
    Turns out my monarch may not be bad. I was getting by with a 550W supply on one Monarch before. I'm thinking the power draw on Campaign 7 is higher than previous projects I ran. The 500W runs it now after I reseated all of the fan controllers on the Monarch, but trips off as soon as it's under load.

    SO: Crazy question, I have 3x6pin inputs on the Monarch. Is it possible to split the load on those between 2 500W power supplies? I'm thinking no, but I just wanted to check if anyone has done it.
    That shouldn't be a problem as long as you short them both out to make sure they both think they're connected to a computer. I did something similar when I was running 4 570's off of 1 mb.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •